Mold In Graphic Systems

About Mold In Graphic Systems® (MIGS): The Future of Labeling for Rotational Molding Rotationally molded products are built to last. Their labels should be too — and they should recycle with them. Since 1983, MIGS has pioneered permanent labeling for the unique demands of rotational molding. While traditional labels — stickers, foils, inks, or films — fail under UV, sanitation, and outdoor abuse, many newer “solutions” also fall short. Systems built on Teslin®-type substrates or multi-material stacks (films, inks, coatings, adhesives) force manufacturers into an impossible equation: durability vs. recyclability. You can’t have both, and at end-of-life these labels contaminate recycling streams, downgrading otherwise valuable HDPE and PP. MIGS Fusion Labeling Technology is different. Our patented mono-material solution fuses pigmented polyolefin into rotomolded parts during the molding cycle itself — no adhesives, no coatings, no contamination. The result is not a sticker or a film layered on, but a molecularly bonded extension of the product that matches the durability of the plastic itself. For applications needing flexibility after molding, our Mold On Graphics® deliver the same fusion permanence post-production. Why MIGS Fusion is the future of labeling in rotomolding: Durability + Circularity Together: Labels last decades and remain 100% recyclable. Regulatory Alignment: Meets ANSI, OSHA, FDA, and global safety standards while supporting EU PPWR, EPR, and Environmental Product Declaration (EPD) requirements. Economic Value: Eliminates scrap, relabeling, and downgrades — preserving resin value and protecting OEM brands. Sustainability by Design: Pure mono-material, compatible with closed-loop recycling and reverse logistics. One label. One time. Built for the future. Since 1983. Connect with our MIGS Brand Specialists at moldingraphics.com, info@moldingraphics.com, or (928) 634-8838.